LISTSERV at the University of Georgia
Menubar Imagemap
Home Browse Manage Request Manuals Register
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2007, week 4)Back to main SAS-L pageJoin or leave SAS-L (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 23 Nov 2007 03:12:57 -0800
Reply-To:     Patrick <patrick.matter@GMX.CH>
Sender:       "SAS(r) Discussion" <SAS-L@LISTSERV.UGA.EDU>
From:         Patrick <patrick.matter@GMX.CH>
Subject:      Re: setup for bi enterprise server
Comments: To:
Content-Type: text/plain; charset=ISO-8859-1

Hi Doug

I assume no one will be able to give you a concrete answer without knowing more about the architecture/system environment already in place. There are different architecture variants possible and it will largly depend on your requirements and restrictions. The Installation Guide will give you an idea:

Be aware that installing is one thing but then to set up the environment needed (all the metadata definitions) is another. It's a huge step and a new approach for someone used to Base SAS and EG. Keep that also in mind from a point of cost and time. The pure installation will be faster and cheaper than what comes after!

It sounds as if you could to spend a bit of money. Why don't you define your problem and get a proposal from SAS. They have normally good pre-sales teams.


Back to: Top of message | Previous page | Main SAS-L page