LISTSERV at the University of Georgia
Menubar Imagemap
Home Browse Manage Request Manuals Register
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 1996)Back to main SPSSX-L pageJoin or leave SPSSX-L (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 17 Apr 1996 09:54:54 -0500
Reply-To:     "Bruce L. Peterson" <brucep@SPSS.COM>
Sender:       "SPSSX(r) Discussion" <SPSSX-L@UGA.CC.UGA.EDU>
From:         "Bruce L. Peterson" <brucep@SPSS.COM>
Organization: SPSS Inc.
Subject:      Re: Min Reqs for SPSS7.0

J. ennis wrote: > > I experienced the same problem and I think that it's because some > of your RAM (640K) is not accessible to the program. So, as best > as I can figure we have 8mb installed but only 7.36 usable. Does > this make sense?

Let me add my $.02 here. I hope this is readable since this is my first post since reinstalling Netscape.

I believe the following question and answer address the original question of this thread.

Question

The installation procedure reports that you have insufficient memory to install SPSS 7.0 for Windows although you have at least 8MB of memory, the minimum amount of physical memory (RAM) required to run SPSS.

Answer

There is a switch you may add to the RUN line that will allow the installation procedure to continue. In the RUN dialog, enter the line:

a:setup -NOENVFAIL

Make sure that you specify the correct drive letter (A or B), that there is a space after 'setup', and that the actual switch, "-NOENVFAIL, is in all capital letters.

This should allow normal installation.

Bruce

-- Bruce L. Peterson * Internet brucep@spss.com Manager, Technical Operations * Voice 312/329-3655 SPSS Inc * FAX 312/329-3668 Chicago IL * CompuServe 72662,1374


Back to: Top of message | Previous page | Main SPSSX-L page