Uday:

The switches that determine the outputs are defined in the simulation
control section under output.  Check your Experimental Details file of this
particular experiment using either the XCREATE program or an ASCII text
editor.  Make sure that the switches for Growth, Water, etc. are set to "Y".

Regards,

Gerritg

At 11:24 AM 8/12/2001 +0530, Uday Khodke wrote:
>Dear Members,
>
>I am using DSSAT 3.5 for simulating peanut growth. After simulating the
>next experiment the model is not saving outputs in the concerned output files.
>
>I want the outputs to be saved  in the output files such as Growth,
>Carbon, Nitrogen, Overview, Summery, Water & Wbal for each experiment
>after simulation.
>
>Only Wbal output file is changing the output after simulation rest are
>showing output of previous run.
>
>Please guide.
>
>Thanks!
>Uday Khodke
>Department of Agricultural & Food Engineering
>Indian Institute of Technology,
>Kharagpur- 721 302
>India
>Email: [log in to unmask]
>Fax +91-3222-82244
>Tel. +91-3222-83138