Dear Sir,

Thank you very much for your prompt reply. Anyway I could trace the problem.

In the "simulation controls: output" if we give the option for first line
i.e. "Files named with experiment code" as " Y" then the all the outputs
will be saved in the files named as EXPT_NAME_CROPCODE+output type, except
the Nbal & wbal. And if the obove option is "N" then all the outputs will be
saved in separate files like carbon.out,growth.out, nitrogen.out, water.out,
etc.

I was searching output in separate files after giving option "Y" so I did
not get. Now it is okey.

With best regards,

Uday
----- Original Message -----
From: Gerrit Hoogenboom <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, August 13, 2001 5:51 AM
Subject: Re: Output Files


> Uday:
>
> The switches that determine the outputs are defined in the simulation
> control section under output.  Check your Experimental Details file of
this
> particular experiment using either the XCREATE program or an ASCII text
> editor.  Make sure that the switches for Growth, Water, etc. are set to
"Y".
>
> Regards,
>
> Gerritg
>
> At 11:24 AM 8/12/2001 +0530, Uday Khodke wrote:
> >Dear Members,
> >
> >I am using DSSAT 3.5 for simulating peanut growth. After simulating the
> >next experiment the model is not saving outputs in the concerned output
files.
> >
> >I want the outputs to be saved  in the output files such as Growth,
> >Carbon, Nitrogen, Overview, Summery, Water & Wbal for each experiment
> >after simulation.
> >
> >Only Wbal output file is changing the output after simulation rest are
> >showing output of previous run.
> >
> >Please guide.
> >
> >Thanks!
> >Uday Khodke
> >Department of Agricultural & Food Engineering
> >Indian Institute of Technology,
> >Kharagpur- 721 302
> >India
> >Email: [log in to unmask]
> >Fax +91-3222-82244
> >Tel. +91-3222-83138