4 messages.---------------Johnnie --------------------------------- >From: Duane F Marble <[log in to unmask]> >Subject: Re: What-d'you-callits. >Date: Mon, 17 Jun 1996 17:13:18 -0400 (EDT) Ah, and what is an "iso-bront?" -- Duane F. Marble E-mail: [log in to unmask] Dept. of Geography Home Page: http://thoth.sbs.ohio-state.edu The Ohio State University Telephone: (614) 292-2250 Columbus, OH 43210 Fax: (614) 292-6213 ---------------------------------------- >Date: Mon, 17 Jun 1996 17:17:54 -0500 >From: [log in to unmask] (James R. Carter) >Subject: Re: What-d'you-callits./ not isopleths >----------------------------Original message---------------------------- Darius wrote: > >Okay, so our question..... if an isoline (or isarithm) is the generic term >for the lines that link points of equal value, what is the corresponding >generic name for the polygon/broad zone that lies BETWEEN succesive isarithms, >(such as the colour-coded zones on a hypsometric map)? I'm guessing at >"isopleth", but would appreciate confirmation or correction.... > As I always learned, and still contend, the isopleth defines derived isolines, such as lines of density. These are not based on data observed at points but on statistics derived for points. Thus, to get a density at a point we must take into consideration the area on which the density value will be based. As we change the sampling area to collect values to computer density, it changes the value of density we will compute. So, there is no observed value at that point, only a derived value. Isopleths are those lines connecting the derived values. And, it follows that an isopleth surface is that surface based on derived data. ======================================================= James R. Carter "Jim" [log in to unmask] Professor of Geography; Director, Laboratory for Integrated Learning and Technology, College of Arts and Science; and Chair, Map Use Commission of the International Cartographic Association Geography/Geology Department, Illinois State University Mail Stop 4400, Normal,IL 61790-4400 USA tel: (309) 438-2833 fax: (309) 438-5310 ------------------------------------------ >Date: Mon, 17 Jun 1996 23:13:03 -0400 >From: [log in to unmask] (P. Andrew Ray) >Subject: Re: What-d'you-callits. I ain't no cartographic guru, but I'll give it a try... According to my "The New Shorter Oxford English Dictionary", isopleth = isoline. In reference to your specific example ("...such as the colour-coded zones on a hypsometric map..."), the term is isochroous (line joining points of the same colour), but I don't think that is what you want either. How about isogenous?? Again, according to my dictionary, isogenous is "equal in kind or nature". Sounds pretty close to me. Or how about isotropic?? "Of a material or a body having the same physical properties in all directions". Hope this helps... P. Andrew Ray Department of Geography The University of Western Ontario ---------------------------------------------------- >Date: Tue, 18 Jun 96 09:46:57 EDT >From: Howitt <[log in to unmask]> >Subject: Re: What-d'you-callits. In map cataloging, the phrase "gradient tints" is used. For example, when cataloging a map where relief is shown by colored bands, the note "Relief shown by gradient tints" would be added. I have only seen this phrase used for elevations and depths, not for other data like temperature, population density, etc. Howard Stone Map Cataloger, Brown University